Appendix B: Wiring Configuration; Wiring Configuration - Agilent Technologies 5DX 5000 Series Installation Manual

Appendix B

Wiring Configuration

This appendix contains the wiring configuration information for the
Agilent 5DX System.
There are two possible wiring configurations for the 5DX: a three phase
wye or delta and a three phase wye with neutral. The drawings in this
appendix show how the Power Distribution Unit (PDU) is wired for those
configurations. It also lists the options associated with each configuration
and lists those options to be used in international locations.
The 220 volt outlet strip wire egress is through the holes on the front of the
Power Distribution Unit. The 220 volt outlet strip for the mobile
workstation table uses the wire egress hole on the left as indicated in Figure
B-1. The Vacion Pump power supply and auxiliary power strip use the wire
egress hole on the right.
Wire Egress for the 220
Volt Outlet Strip for the
Mobile Workstation
Table (monitor)
Figure B-1 PDU Wire Egress
Agilent 5DX Installation
Wiring Configuration
E1135C
POWER DISTRIBUTION UNIT
!
ON
MAINS
100-240V ~ 1 o
50-60 Hz
200-240V ~ 3 o
OFF
200-415V ~ 3 o
80A MAX
___VAC ___ o ___ FLA
!
CB2 CB1
!
CB4 CB3
0 1
CB6 CB5
CB8 CB7
CB10 CB9
Wire Egress for the 220 Volt
Outlet Strip for the Vacion Pump
Power Supply, High Voltage
Power Supply and X-ray Tower
fan
Wiring Configuration B-49