Table of Contents
Advertisement
This drawing is provided for
reference. As long as the
cable tether is kept in place,
the cables should remain
installed correctly.
The cable bundle from the main unit
is routed through the larger hole in
the bottom panel. The bundle
containing the monitor, keyboard,
etc. cables goes out the smaller hole.
Each hole has a removable cable
clamp to make cable routing easier.
It is best to remove the whole panel
to route the cables initially.
Cables from the main unit and from
the electronics bay are labeled. The
labels indicate where each cable
should be routed. Cables from the
electronics bay are labeled for their
routing to the workstation table.
Power to the mobile workstation
table and the main cabinet
AC Main (installed by the
customer's electrician)
Figure 8
Cable Harness Routing
Agilent 5DX Installation
Electronics Bay (rear view)
1
0
!
(The electronics
bay is shown
without the rear
door.)
Keyboard, mouse,
monitor, etc. are
routed out here.
Cables from the main
unit are routed into
here.
17
Advertisement
Table of Contents
