Table of Contents
Advertisement
Hardware Reliability Functional Checks
11.
hardware is functioning properly, perform the following steps:
From the
a.
select
From the DOS prompt type
b.
NOTE
This command will initiate and repeat the automatic inspection
mode for the confirmation and adjustment board.
Select Test. Select
c.
through to the start of inspection mode.
When the first test run is completed, the process should continue to
d.
repeat without operator interaction. Allow the demo inspection mode
to run for a minimum of two hours. If convenient at the time, let the
tests run overnight.
Press Esc to stop the inspection when done.
e.
When the demo period is complete, from the
f.
menu, select
Enter
g.
pressing Enter.
Final Adjustments
12.
Confirm and Adjust > Adjust > All.
run in proper order. Remain at the controller, some intervention or
input may be required during adjustment cycle. Run self-test setup.
When completed, run the self-test. Select
File Backup and Restore
13.
Select
a.
38
User Interface
Quit from
5DX.
Panel
Quit from
User Interface
from the DOS prompt by typing
— Perform the final adjustments by selecting
from the Confirm and Adjust menu and press Enter.
Adjust
System Access
menu, select
auto -demo
and press Enter. Follow the menu steps
5DX.
All of the adjustments will
Adjust > Self-test > Run.
— Run the backup utility.
— To verify that system
menu,
and press Enter.
System Access
auto
Agilent 5DX Installation
and
Advertisement
Table of Contents
