Table of Contents
Advertisement
to in the Site Preparation Guide) that is provided by local facilities.
Do not plug a printer that requires 108-110 volts in to the
Caution
workstation power supply on the 5DX. This power supply is 200-
208 or 220-240 volts. Damage will occur to the printer.
Customers outside the United States and Canada receive printers
requiring 220-240 Volts. These printers can be plugged in to the power
supply mounted on the workstation cart or to any wall outlet providing
the correct 220-240 volts.
Compressed Air and Filter Canister Assembly
13.
filter canister by inserting and turning counter-clockwise. Connect the
facility air input line. (see Figure 9)
NOTE
The air filter and connection are located on the lower rear of the
main cabinet. Verify the input air supplied is at least 5.6 Kg/cm
(80 psi or 550 kpa), and adjust if required. The air supply should
also be free of contaminants such as debris, oil or water
Agilent 5DX Installation
— Install the air
2
19
Advertisement
Table of Contents
