Table of Contents
Advertisement
Overview
This document is intended to guide you through the Agilent 5DX
installation process. All major steps have check boxes like this:
the left side of the page. Use these check boxes as you proceed with the
installation to ensure all steps of the installation are complete.
Installation is intended to be performed by qualified Agilent
NOTE
Customer Engineering personnel only.
Preparing for Agilent 5DX Installation
You may need to refer to the following documents.
• Unpacking Instructions (N7200-90075-C)
• Site Preparation Manual (N7200-90109)
• Agilent 5DX System Administration Manual (N7200-90124) (This
document is also on-line.)
• 5DX Service Guide (on-line document)
• Agilent Electrostatic Discharge Control Specification (A-5951-1589-1)
• Agilent X-Ray Safety Test Procedure (5021-1979) and X-Ray Safety Test
Report (N7200-90092)
The unpacking instructions (N7200-90075-C) will be located on the
outside of the crate. The Site Preparation Manual has been sent to the
customer before this installation began. The Service Guide and System
Administration Manual are on-line when you get the system up and
running. The ESD document is one of general corporate nature that you
should already be familiar with, if you are not, please review it as soon as
possible.
Agilent 5DX Installation
on
Agilent 5DX Installation
Advertisement
Table of Contents
