Table of Contents
Advertisement
Be careful of cables, hoses, etc.,
(see the note below about forklift
caution.)
Forklift tines should be
than 17.5 centimeters (6.75
inches) wide,
set to 87.5 cm (34.5
inch) center-to-center distance apart
and be 152 cm (60 inches) long
(minimum)
(Rear of 5DX shown)
Figure 2
System Arrival
Caution
Lift the system where shown only. Do Not use a lift or jack on
the rest of the frame or system damage could occur.
Check for Gross Damage
1.
packing materials, etc. Note any areas where the equipment has been
exposed. Document any damage on the waybill. Note the two
Tiltwatch Indicators and Drop Monitor. These indicators must not
have been tripped during shipment or the system may be damaged.
Advise the carrier and contact
immediately. If significant damage exists, document the damage
completely (take pictures if possible) prior to further unpacking or
movement.
Agilent 5DX Installation
no more
— Look for and record any damage to
Agilent 5DX Support Services
Use fork lift here
ONLY
5
Advertisement
Table of Contents
