Wiring Field-Supplied Actuators To The Analog Output; High-Torque Actuators - Carrier TruVu VVTBP-E2 Installation And Startup Manual

Wiring field-supplied actuators to the analog output

You can wire a high-torque actuator or parallel actuators to the controller's 0–10 Vdc analog output.
NOTE You cannot use the TV-VVTBP-E2's actuator if wiring external actuator(s) to the analog output.

High-torque actuators

You can wire one of the following Belimo actuators to the TV-VVTBP-E2's analog output instead of using the
controller's 45 in.-lb (5 Nm) actuator.
NMX24-MFT P-10028
AMX24-MFT P-10028
Install the actuator according to the manufacturer's instructions.
1
Wire the actuator to the controller using the diagram below.
2
NOTE For proper operation and to prevent damage to the devices, use the same polarity for the actuator's power
and the TV-VVTBP-E2's power.
TruVu™ VVTBP-E2
Installation and Start-up Guide
90 in.-lb (10 Nm) actuator with 0–10 Vdc control and 0–10 Vdc
feedback
180 in.-lb (20 Nm) actuator with 0–10 Vdc control and 0–10 Vdc
feedback
33
Wiring field-supplied actuators to the analog output
©2022 Carrier.
All rights reserved.