Bacnet Firewall - Carrier TruVu VVTBP-E2 Installation And Startup Manual

Adjusting the TV-VVTBP-E2 driver properties
IP Configuration
Allow setup of IP addressing
through an external tool
Enable IP configuration
changeover

BACnet Firewall

If this IP controller is accessible from the Internet, you can increase security by enabling its BACnet firewall. When
enabled, this feature prevents the controller from responding to BACnet messages from unidentified sources and
allows communication only with IP addresses that you define. These can be all private IP addresses and/or a list
of IP addresses. Follow the instructions in the i-Vu® interface to set up the BACnet firewall.
TruVu™ VVTBP-E2
Installation and Start-up Guide
When this field is enabled, you can set up IP addressing through a tool. IP
addressing is typically set up through the Service Port.
Only for custom static IP addressing—Select this field to remotely change the
controller's IP Address, Subnet Mask, and Default Gateway Address.
Type the new addresses and the UDP Port that your server is using to
communicate to all controllers.
In the Changeover timeout field, enter:
•
A specific length of time for the controller to attempt to communicate with the
Next Default Gateway Address. The controller will use the Next setting as
soon as the controller can communicate with the Next Default Gateway
Address, or when the timeout occurs, whichever comes first.
•
0:00 to have the controller use the Next settings as soon as the controller
can communicate with the Next Default Gateway Address.
See "To remotely change a controller's IP address" in i-Vu® Help for more
information on using this feature.
50
©2022 Carrier.
All rights reserved.