Carrier TruVu VVTBP-E2 Installation And Startup Manual page 68

To set up the controller through the Comm/Service ports
Local Devices table
Blink
NOTE If a device's IP address is the loopback address (127.0.0.1), it is considered unconfigured and unlocked.
The IP address, subnet mask, and default gateway fields are blank in the Ports and Local Network tabs. You can
configure it in the Local Devices table.
TruVu™ VVTBP-E2
Installation and Start-up Guide
Click the Blink button to prompt the Locator LED to flash for 15 seconds,
allowing you to verify the controller's physical location. After flashing, whenever
the actuator moves, the LED rotates in the same direction. LED rotation is
automatically disabled after 1 hour and can be re-enabled by pressing the Blink
button again.
NOTES
•
The blue dot appears when you Blink a device.
•
You can Blink a locked device.
62
©2022 Carrier.
All rights reserved.