Wiring Field-Supplied Actuators To The Analog Output - Carrier VVT Bypass II Installation And Startup Manual

To wire and mount the DAT sensor
1
Wire the sensor to the controller. See diagram below.
NOTE Sensor wiring does not have polarity. The wires can be connected to either terminal.
2
Using electrical tape, insulate any exposed wire to prevent shorting.

Wiring field-supplied actuators to the analog output

You can wire a high-torque actuator or parallel actuators to the controller's 0–10 Vdc analog output.
NOTE You cannot use the VVT Bypass II's actuator if wiring external actuator(s) to the analog output.
VVT Bypass II Controller
Installation and Start-up Guide
17
Installing the VVT Bypass II
CARRIER CORPORATION ©2019
All rights reserved