To Configure Custom Prog 1/2 Leds; To Get A Module Status Report - Carrier TruVu VVTBP-E2 Installation And Startup Manual

Troubleshooting

To configure custom Prog 1/2 LEDs

You can customize the Prog 1 and/or Prog 2 LED for site-specific purposes by configuring the BACnet Analog
Output (BAO) microblock.
Open your control program in the Snap interface, select the AO microblock for each LED, and use the following
settings:
Status/Attribute
LED 1
LED 2

To get a Module Status report

A Module Status report provides information about the controller and verifies proper network communication with
the controller. You can get this report:
•
In the i-Vu® application—Right-click the controller on the navigation tree, then select Module Status.
•
In the Field Assistant application—Right-click the controller in the navigation tree and select Module Status.
•
On the controller setup ModStat tab—See To set up the controller through the Service Port (page 57).
See Module Status field descriptions (page 82) in the Appendix.
TruVu™ VVTBP-E2
Installation and Start-up Guide
Microblock Expander number :
type Channel number
BAO 0:61
BAO 0:62
70
I/O type Description
Special
•
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of
times given in the BAO with ON
pulse 0.5 seconds and OFF pulse
0.5 seconds.
Special •
<=0 Normal
•
>15 On
The number of blinks equals the
Present Value.
The pulse pattern repeats after a
2-second delay
LED will blink the number of
times given in the BAO with ON
pulse 0.5 seconds and OFF pulse
0.5 seconds.
©2022 Carrier.
All rights reserved.