Wiring A Field-Supplied High-Torque Actuator To The Analog Output - Carrier TruVu VAVB3-E2 Installation And Startup Manual

Wiring equipment to the TV-VAVB3-E2's outputs

Wiring a field-supplied high-torque actuator to the analog output

You can wire one of the following Belimo actuators to the TV-VAVB3-E2's analog output instead of using the
controller's built-in, 45 in.-lb (4 Nm) actuator.
NMX24-MFT P-10028
AMX24-MFT P-10028
Install the actuator according to the manufacturer's instructions.
1
Wire the actuator to the controller using the diagram below.
2
NOTE For proper operation and to prevent damage to the devices, use the same polarity for the actuator's power
and the TV-VAVB3-E2's power.
TruVu™ VAVB3-E2
Installation and Start-up Guide
90 in.-lb (10 Nm) actuator with 0–10 Vdc control and 0–10 Vdc feedback
180 in.-lb (20 Nm) actuator with 0–10 Vdc control and 0–10 Vdc feedback
54
CARRIER CORPORATION ©2022
All rights reserved