Mounting The Tv-Vvtbp-E2 - Carrier TruVu VVTBP-E2 Installation And Startup Manual

Mounting the TV-VVTBP-E2

Mounting the TV-VVTBP-E2
To mount the TV-VVTBP-E2
Turn the damper shaft to fully close the damper position. Ensure the damper is closed.
1
Mount the controller to the bypass duct by sliding the clamp assembly onto the damper shaft.
2
Mount and secure an enclosure to cover the TV-VVTBP-E2.
3
NOTE For service access, allow at least 1 foot (.3 m) of clearance between the front of the enclosure and
adjacent surfaces.
TruVu™ VVTBP-E2
Installation and Start-up Guide
10
©2022 Carrier.
All rights reserved.