Linked Actuators - Carrier TruVu VVTBP-E2 Installation And Startup Manual

Wiring field-supplied actuators to the analog output

Linked actuators

You can wire up to 4 of the following Belimo actuators to the TV-VVTBP-E2's analog output. Link actuators whose
travel times and other parameters coincide.
LMX24-MFT P-10028
NMX24-MFT P-10028
AMX24-MFT P-10028
Install the actuators according to the manufacturer's instructions.
1
Wire the actuators to the controller using the diagram below.
2
Set the direction rotation switch on each actuator to CW.
3
TruVu™ VVTBP-E2
Installation and Start-up Guide
45 in.-lb (5 Nm) actuator with 0–10 Vdc control
90 in.-lb (10 Nm) actuator with 0–10 Vdc control
180 in.-lb (20 Nm) actuator with 0–10 Vdc control
34
©2022 Carrier.
All rights reserved.