Carrier TruVu VVTBP-E2 Installation And Startup Manual page 26

Addressing a network of controllers using the controller setup Local Network tab
The following are two possible methods you could use to identify and assign a network of controllers' addresses
after following steps 1 - 4 above.
•
Two technicians can work together if they are communicating throughout the process. The first technician
physically travels around the building to each controller, tells his co-worker exactly where he is, and then
presses the DSC button. The second technician, who is sitting at a computer connected to the controller,
watches for the blue dot to show up on the Local Devices table on the Local Network tab, where he can enter
the appropriate addressing and identifying information.
•
One technician alone can address the controllers on a mobile device showing the Local Network page by
plugging the Carrier wireless service adapter into a controller's Service port. Then, with the computer, move to
each controller within 100 ft. of the adapter. Pressing the DSC button on the controller displays a blue dot in
the table where the addressing information can be entered.
TruVu™ VVTBP-E2
Installation and Start-up Guide
20
©2022 Carrier.
All rights reserved.