Scr Electric Heat (Ducted Or Baseboard) - Single Duct Application; Wiring A Field-Supplied High-Torque Actuator To The Analog Output - Carrier VAV Zone II Installation And Startup Manual

Installing the VAV Zone II

SCR electric heat (ducted or baseboard) - Single duct application

VAV Zone II Fan Terminal Controller

Wiring a field-supplied high-torque actuator to the analog output

You can wire one of the following Belimo actuators to the VAV Zone II's analog output instead of using the
controller's built-in, 45 in.-lb (4 Nm) actuator.
NMX24-MFT P-10028
AMX24-MFT P-10028
Install the actuator according to the manufacturer's instructions.
1
VAV Zone II Controllers
Installation and Start-up Guide
90 in.-lb (10 Nm) actuator with 0–10 Vdc control and 0–10 Vdc feedback
180 in.-lb (20 Nm) actuator with 0–10 Vdc control and 0–10 Vdc feedback
38
CARRIER CORPORATION ©2019
All rights reserved