Dexcom G5 User Manual page 310

Guidance and Manufacturer's Declaration – Electromagnetic Immunity
The receiver (MT22949) is intended for use in the electromagnetic
environment specified in the next table. The customer or the user of the
receiver should ensure that it is used in such an environment.
Receiver Electromagnetic Immunity Specifications
Immunity Test
Electrostatic
Discharge (ESD)
IEC 61000-4-2
Electrical Fast
Transient/Burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Surge
IEC 61000-4-5
Voltage Dips, Short
Interruptions and
Voltage Variations
on Power Supply
Input Lines
IEC 61000-4-11
IEC 60601-1-11
Power Frequency
(50/60 Hz) Magnetic
Field
IEC 61000-4-8
NOTE: U is the a.c. mains voltage prior to application of the test level.
T
Guidance and Manufacturer's Declaration – Electromagnetic Immunity
Dexcom G5 Mobile System User Guide
Technical Information
IEC 60601 Test
Level
± 8 kV Contact
± 15 kV Air
± 2 kV for power supply
lines
± 1 kV for
input/output lines
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
± 1 kV line(s) to line(s)
± 2 kV line(s) to earth
U
0% for 1 cycle
T
U
0% for 0.5 cycle at
T
8 phase angles
U U
70% (30% dip in
T
for 25 cycles
U
0% for 250 cycles
T
30 A/m
Transmitter
Compliance
Level
± 8 kV Contact
± 15 kV Air
± 2 kV for power supply
lines
Not applicable
± 1 kV line(s) to line(s)
Not applicable
± 1 kV line(s) to line(s)
Not applicable
U
0% for 1 cycle
T
U
0% for 0.5 cycle at
T
8 phase angles
U
) 70% (30% dip in
T T
for 25 cycles
U
0% for 250 cycles
T
30 A/m
Electromagnetic
Environment Guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
U environment.
)
T
Power frequency magnetic fields
should be at levels characteristic of
a typical location in a typical
commercial or hospital
environment.
310