System Wiring Diagrams - Leica PaveSmart 3D User Manual

3.2
General information

System Components, Diagrams, Software Description

System Wiring Diagrams

The system wiring is dependent on the purchased/installed solution. The main installation is
identical, only the serial port sensor combination may vary depending on the sensor equip-
ment used. It is possible to attach up to four Robots (when linked to machines using CANBus
interfaces) or up to 2 GPS sensors.
• The MPC1310 must be mounted with the bracket supplied. The rear of the MPC1310
should be free from obstructions to allow sufficient cooling.
• Mast(s) must be fixed firmly to the frame of the machine so minimum vibration is expe-
rienced.
• Slope sensors must be mounted at the appropriate point of the machine with the arrow
facing forward in direction of production.
Use the machine-manufacturer-supplied slope sensor mounting bracket wher-
ever possible.
• Where applicable: Alternatively to the TCPS27S or TCPS29S ruggedised radio modems,
approved third party radio modems, such as MCR-900, with appropriate cables can be
used. Refer to the Leica PaveSmart 3D Technical Reference Manual for machine-specific
details.
PaveSmart 3D UM 83