Leica PaveSmart 3D User Manual page 101

Troubleshooting
Problem Possible cause(s)
• Radio interference or cabling
damaged
• MGuide is not installed
• Low power at machine
Robot does not • MGuide application is in config-
react on uration mode
commands
• MGuide is in As-Built dialog
• Auto-Shutdown at instrument
GPS sensor is not • Communication parameters on
initialised sensor are not set correct
• Baud rate is not identical on
instrument and in the software
GPS position • Wrong transformation file
accuracy is bad loaded
• No reference signal available
• Bad satellite distribution
• Not enough satellite available
Suggested remedies
• Install MGuide application and
choose appropriate Config Set
• Contact Leica Geosystems
• Ensure that the radio handle is
on the correct way with the
lights facing the operator and
the antenna facing the paver.
• Turn on the paver as power
supply may not be sufficient if
the paver is not running
• Change to MGuide main menu
• Solve instrument error message
(refer to robot manual)
• Unplug power cable and restart
robot
• Set correct Config Set on sensor
• Check communication parame-
ters on sensor
• Contact Leica Geosystems
• Check transformation file on
sensor
• Check reference signal
• Contact Leica Geosystems
• Check radio configuration
between GPS and base station
PaveSmart 3D UM 101