Leica PaveSmart 3D User Manual page 13


Getting Started
Set up Fixpoint Prisms over suitable fixpoints, noting their heights, ready for Free Station
or Known Point Setups.
Once all robots and prisms are set up, on each Robot, Level and perform either a Resection
(Free Station) or Known Point Setup (refer to the MGuide Application Program Manual or
the Robot User Manual, depending on your type of instrument/work flow).
If working with GPS (GNSS) start the reference station to obtain correction data for the GPS
machine sensor (refer to the Leica GPS Machine Positioning User Manual).
At the Leica PaveSmart 3D computer: In the dialog Work\Sensors\Arrange, select which
sensor will be used as <Primary>, depending on configuration profile, and optionally as
<Secondary> and <Spare>.
Switch on machine and allow hydraulic system to warm to a suitable operating tempera-
ture before starting work. This step is essential to ensure consistent machine behaviour, as
the machine will have been "tuned" by a Leica Geosystems engineer during initial commis-
sioning of the system at its normal operating temperature, engine speed and oil pressure.
PaveSmart 3D UM 13