Leica PaveSmart 3D User Manual page 22

Getting Started
a) Dashboard/Error messages: the specific icon flashes yellow if a warning is detected or
flashes red if an error occurs. By pressing the specific button additional information and trou-
bleshooting tips will be displayed.
1.) MPC1310 messages
2.) Communication messages
3.) Sensor messages
4.) Machine messages
b) Corrections: indicates the required corrections for the elevation and cross slope of the milling
head and the position of the milling head. For example, if the height correction shows 0.010
(in m or ft), the machine has to lower the milling head by 0.010 (in selected units). The values
and settings are exactly the same as those values displayed on the machine controller (Wirtgen
DLS or LevelPro, or MOBAmatic) and can be changed manually on the controller or automati-
cally through PaveSmart 3D.
c) Design Map display: shows the whole project and the current machine position. Click on the
Map to select the desired Reference Line and Slope Line.
d) Information: provides information about the work progress.
• Stationing current Stationing or Chainage (in selected units).
• Opposite Stationing shows the inverted Stationing or Chainage, i.e. the distance to
the end of the current Reference Line.
• Speed indicates current Speed of the machine (in m/min or ft/min).
• Milling Height - calculated height of the control point at the mast foot point.
• Design Height - project design height at the current machine position.
• Layer Offset - working height offset, added/subtracted to the design elevation.
• Slope Offset is the active offset when working with a slope side.
e) opens the Sensor dialog to manage Robot and GPS sensors.
f) opens the Offset dialog to set the working offsets relative to the ReferenceLine and
SlopeLine.
PaveSmart 3D UM 22