Leica PaveSmart 3D User Manual page 19

Getting Started
3.) Sensor messages
4.) Machine messages
b) Corrections: indicates the mold "deviations", and required corrections for the elevation of the
mold (front and rear) and the position of the mold (front and rear). For example, if the front
height deviation shows -0.013 (in selected units), the machine has to raise (i.e. correct) the
front of the mold by 0.013 (in m or ft). In normal operation, with the machine's controller set
to Automatic, the deviations should be around zero at all times.
c) Design Map display: shows the whole project and the current machine position. Click on the
map to select the desired ReferenceLine and SlopeLine for controlling the machine.
d) Information: provides information about the work progress.
• Stationing shows current Stationing or Chainage (in selected units).
• Opposite Stationing shows the inverted Stationing or Chainage, the difference to
the end (in selected units).
• Speed indicates current Speed of the machine (in m/min or ft/min).
• Working Slope shows the current Working Slope, which is the Design Slope at the
current position plus the Slope Offset.
• Design Slope is the Design Cross Slope at the current position. It is calculated out of
the ReferenceLine and the SlopeLine.
e) Press and hold for at least 1 second to start active Control.
f) opens the Sensor dialog to manage Robot and GPS sensors.
g) opens the Offset dialog to set the working offsets relative to the selected
Reference Line and Slope Line.
h) opens the Main Menu dialog to configure Leica PaveSmart 3D settings, such as
Machine, Project, Sensors etc.
PaveSmart 3D UM 19