Leica PaveSmart 3D User Manual page 28

Getting Started
The Work dialog screen shows all the information needed while the machine is in
operation.
a) Dashboard/Error messages: the specific icon flashes yellow if a warning is detected or
flashes red if an error occurs. By pressing on the specific button additional information and
troubleshooting tips will be displayed.
1.) MPC1310 messages
2.) Communication messages
3.) Sensor messages
4.) Machine messages
b) Corrections: indicates the required corrections for the four elevation cylinders of the mold
(left/right and front/rear) and the position of the mold (steer front/rear) relative to the
selected Reference Line, Slope Line and Working Offsets. For example, if the Left Front height
correction shows -0.013 (in m or ft), the machine has to raise the left front of the mold by
0.013 (in m or ft).
c) Information: provides information about the work progress like Stationing/Chainage, Speed,
Design Slope, Next Action and Sensor Information.
d) Design Display: shows the whole project and the current machine position. Click on the map
to select the desired Reference Line and Slope Line.
e) Press and hold for at least 1 second to start Active Control. Control will only start if
all required sensors are connected, machine dimensions and Primary/Secondary control points
defined.
f) opens the Sensor dialog to manage Robot and GPS sensors.
g) opens the Offset dialog to set the working mold offsets relative to the selected
ReferenceLine and SlopeLine.
PaveSmart 3D UM 28