Leica PaveSmart 3D User Manual page 102

Troubleshooting
Problem Possible cause(s)
Leica PaveSmart • Flash disk is full
3D is not reacting
• System has crashed
to user input by
touchscreen or
keyboard
Strange behaviour • Slope sensor incorrectly orien-
- machine lifts tated/adjusted
legs incorrectly
• Robot incorrectly oriented
and/or drives off
• Machine not in Leica/Automatic
steering line
mode
• Hydraulic tuning not appro-
priate
• Mold Adjust values may be
required to compensate for
poor mold/frame alignment
PaveSmart 3D UM 102
Suggested remedies
• Remove unnecessary Jobs or log
files
• Reboot computer
• Check installation and readjust
slope sensor as required
• Perform a Tiepoint check to
verify robot orientation (if
necessary new Resection)
• Check Machine Controller: All
control loops must be in auto-
matic
• Refer to Mold Adjust instructions
in this Manual