Table of Contents
Advertisement
Getting Started
and <Elevation Check Point: Left>. The selected spot on the milling head is then measured
or brought directly in relation to the control point hub.
The <Reference Point Elevation> is manually entered by the operator.
the sensor starts measuring. This may take a few seconds as several measure-
ments are taken during this time.
The <Measured Check Point Elevation> is the current elevation of the milling head, meas-
ured with the GPS sensor.
The difference between the measurement and the reference point elevation is the <Current
Sensor Elevation Offset>.
stores the current sensor elevation offset. From now on this offset is considered
in the calculation until a new offset is determined with the Bench function again.
continues and rejects the currently determined offset. The previously used offset
will be used again.
PaveSmart 3D UM 71
Advertisement
Table of Contents
