Table of Contents
Advertisement
Figure3-1 Removing the drive
1
4.
Use a Phillips screwdriver to remove the four fastening screws from the drive carrier.
5.
Pull the drive slowly out of the drive carrier.
Keep the removed drive secure for future use.
Figure3-2 Removing the drive carrier
6.
Install a new SATA drive. For more information about installing a SATA drive, see
SATA
If you are not to install a new SATA drive, install a filler panel in the slot.
Replacing a SIC interface module
CAUTION:
• Only the SIC-M2-SATA and SIC-5G interface modules are hot swappable. Before replacing a SIC
interface module except for the SIC-M2-SATA and SIC-5G, make sure the device is powered off.
• Before removing a SIC-5G module, execute the
REMOVE button for more than 0.5 seconds and wait for the remove LED to turn off. The device
might reboot unexpectedly if you remove a SIC-5G module with its remove LED on.
To replace a SIC:
1.
Loosen the captive screws on the SIC. Then pull the SIC slowly out of the slot along the guide
rails.
2.
Install a new SIC in the slot. For information about the installation procedure, see
SIC interface
3
drive."
module."
2
3
4
command or press and hold the
remove
22
"Installing a
"Installing a
Advertisement
Table of Contents
