Replacing A Sic Interface Module - H3C MSR3610-I-DP Installation Manual

Replacing a SIC interface module

CAUTION:
SICs are not hot swappable. Make sure the device is powered off before you remove a SIC.
To replace a SIC:
Loosen the captive screws on the SIC. Then pull the SIC slowly out of the slot along the guide
1.
rails.
Install a new SIC in the slot. For information about the installation procedure, see "Installing a
2.
SIC interface module."
If you are not to install a new SIC, install a filler panel in the slot and fasten the screws on the
filler panel.
Figure 19 Removing a SIC
1 2
23