Serial Port Setup - Intermec EasyCoder C4 Programmer's Manual

Y – Serial Port Setup
Description
Syntax
Parameters
Remarks
Example
Intermec EasyCoder C4 – Programmer's Guide Ed. 3
This command is used to establish the serial port communication parameters.
Yp ,p ,p ,p
1 2 3 4
p Baud rate:
1
19 19,200 baud.
96 9,600 baud.
48 4,800 baud.
24 2,400 baud.
12 1,200 baud.
p Parity:
2
O Odd. (O is uppercase o character; ASCII 79 dec.).
E Even.
N None.
p Number of data bits:
3
7 7 data bits.
8 8 data bits.
p Number of stop bits:
4
1 1 stop bit.
2 2 stop bits.
After receiving this command, the printer will automatically reset its communication
on the serial communication port.
By default, the printer is set for 9600 baud, no parity, 8 data bits, 1 stop bit.
XON/XOFF handshaking is always used. The printer sends XOFF when an error
occurs. RTS/CTS is not supported
If the current communication setup is not known, it can be checked by printing
a test label (see Chapter
Y19,O,7,1
1).
Chapter 7 Commands
:Sets 19,200 baud, odd parity,
7 data bits, 1 stop bit
96