Editing In Form Edit Mode Example - Intermec EasyCoder C4 Programmer's Manual

Editing in Form Edit Mode
Example
Intermec EasyCoder C4 – Programmer's Guide Ed. 3
Assuming that...
• the printer has been set up for the application (see
• the length of the label and the gap has been determined by printing
a Test Label (see Chapter
• and the graphic used in the example has been downloaded to the
printer (see GM command
...we will now edit a label that can be saved as a form in the printer's
memory and retrieved when so required. It also means that we can
use counters and variables.
When we are fi nished, the label will look like this:
1
/. The Intermec logotype is not included in the software package
and is only included in the example to demonstrate how to
print a graphics fi eld. You can substitute it with any graphics of
approximately the same size. If you fi nd it diffi cult to download
graphics, you could omit the
you have become more familiar with the concept.
1),
1
),
GG command from the example until
Chapter 5
Chapter 3),
15 15