Enable Top Of Form Backup - Intermec EasyCoder C4 Programmer's Manual

JF – Enable Top of Form Backup
Description
Syntax
Remarks
Example
Intermec EasyCoder C4 – Programmer's Guide Ed. 3
This command enables automatic top of form backup of the media.
JF
Top of form backup is used in connection with the
printer feed out an extra amount of media after printing the label, as to allow the
media to be torn off or peeled off properly.
By default, top of form is enabled, that is the media is pulled back before
printing the fi rst label in next batch as to allow the printing to start at the
top of the label.
Top of form backup can be disabled by a
be ignored, and the printer will stop feeding when the end of the label becomes
aligned with the printhead's dot line. However, the
memory and can be enabled again using a JF command.
JF
Chapter 7 Commands
j command, which makes the
JB command, that is any
j command is kept stored in
:Enables top of form backup
j command will
60