Intermec EasyCoder C4 Programmer's Manual page 23

Example, cont.
Command
FR"TEST"
?
EASYCODER
501SA
Dan
P1,2
Command
?
Sam
200000
P1,1
Intermec EasyCoder C4 – Programmer's Guide Ed. 3
The example below demonstrates that it is not necessary to set the
counter start value again. The counter internally keeps track of the
last number issued as long as the power remains switched on and is
updated according to instructions in the form.
Explanation
CR/LF to start command structure
Retrieve form
Call for variables
Substitute variable V00
Substitute variable V01
Substitute variable V02
CR/LF to use existing counter value
Print 2 copies of 1 label
Once a form has been retrieved, it can be used over and over
again until another form is retrieved. All variable input data and
counter values are stored in the volatile memory, which means
they will be lost if the printer is switched off or at a power failure.
If prompts are enabled, existing data and counter values will be
displayed on the screen after the related prompt. Any input data
can be overwritten at will.
Explanation
Call for variables in same form
CR/LF to use existing data in V00
CR/LF to use existing data in V01
Substitute data in variable V02
Substitute counter start value
Print 1 copy of 1 label
IMPORTANT!
Note that the question mark (?) following the
essential for the printing of certain fi elds edited in the Form Edit
Mode, that is fi elds containing variables or counters. Variables
and counter start values must be entered or accepted as described
above. If no question mark is transmitted, all fi elds containing
variable input, that is variables and counters will be completely
omitted from the printout.
Chapter 6 Retrieving and Printing a Form
FR command is
22