Intermec EasyCoder C4 Programmer's Manual page 68

M – Memory Allocation, cont.
Remarks, cont.
Intermec EasyCoder C4 – Programmer's Guide Ed. 3
Memory Cartridges
The printers can be fi tted with a memory cartridge containing an additional 256K
of SRAM and/or 1 MB fl ash memory.
256K SRAM Cartridge
Expands image buffer by 256K to a total of 426K.
1 MB Flash Cartridge
Expands form, graphics, and external font memory areas by 1MB to a total
of 1.2 MB.
Checking the Memory Allocation
The amount of memory and the current allocation can be printed on a label using the
command, or by printing a test label in the Dump Mode, see
When to Re-allocate the Memory
• If you need to change the size of the forms memory to accommodate more
or less forms.
• If you need to change the size of the graphics memory to accommodate
more or less graphics.
Image Buffer
The image buffer is the area where the active print image is temporarily stored.
Calculate if you need to expand the image memory by means of an SRAM memory
cartridge by measuring the largest full width form intended to be printed (take
future needs into consideration).
For less than full width labels, also refer to the
print width for increased label length with the same image buffer size.
Chapter 7 Commands
page 4.
q command, which allows trading off
U
67