Otto Bock 17KO1 Series Instructions For Use Manual page 108

Appendices
INFORMATION
No status display due to battery deep discharge
If the status of the component is not displayed on the control panel, the battery may be deep discharged. In this
case it must be charged for at least 15 minutes before the status can be queried again.
Sym­ Beep Vibra­
bols on signal tion sig­
the nal
control
panel
All sym­ —
bols on
the
control
panel
light up
alter­
nately
—
1 x short 1 x long
and 1 x
— 1 x
at interval
of
approx.
5 secon­
ds
—
30 x long 30 x long Severe error/indication of safety
108
Event
— Test of the indicators (LEDs) after
connecting the battery charger
— The product is switched on and
ready for operation
The product was switched on by
pressing the
short panel.
long Overheated hydraulics
— A self-test error was detected when
connecting the battery charger.
mode activation (see Page 102)
Switch to safety mode if possible.
Required action
Check whether all symbols (LEDs) light up
alternately and in the corresponding col­
ours.
If a symbol (LED) does not light up in a
colour, the product should be inspected by
an authorised Ottobock Service Center.
If no symbols (LEDs) light up, the battery
may be deep discharged. Leave the bat­
tery
15 minutes and then repeat this test by dis­
connecting/connecting the battery char­
ger.
button on the control
Reduce activity.
•
•
Walking possible with restrictions. Please
note the possible change in flexion/exten­
sion resistance.
1. Attempt to reset this error by switching
2. If the beep/vibration signal recurs,
3. If the beep/vibration signal recurs, use
charger connected
Conduct the self-test again by connect­
ing/disconnecting the battery charger.
If the symbol lights up again, the
product must be inspected by an
authorised Ottobock Service Center.
For disassembly of the joint unit, see
the section "Assembling/disassembling
the joint unit on the orthosis" (see
Page 79).
the product off/on (see Page 97).
attempt to reset this error by connect­
ing/disconnecting the battery charger.
of the product is prohibited. The
product must be inspected by an
authorised Ottobock Service Center.
For disassembly of the joint unit, see
the section "Assembling/disassembling
the joint unit on the orthosis" (see
Page 79)
C-Brace joint unit 17KO1=*
for at least