Otto Bock 17KO1 Series Instructions For Use Manual page 109

Sym­ Beep Vibra­
bols on signal tion sig­
the nal
control
panel
—
—
—
—
—
—
3 x long 3 x long Charge level between 5% and 10%
5 x long 5 x long Charge level between 0% and 5%
10 x long 10 x long Charge level 0%
4 x short
at inter­
vals of
approx.
65 sec.
(continu­
ously)
—
—
— 1 x long
— — 3 x short Charging mode started (3 sec. after
— 1 x short 1 x short Mode switching or changing adjust­
C-Brace joint unit 17KO1=*
Event
— Charge level 10% to 34%
— Charge level 34% to 67%
— Charge level 67% to 100%
Indicates that the battery is fully
charged during the charging pro­
cess.
— Battery is being charged, charge
level is less than 34%
— Battery is being charged, charge
level is 34% to 67%
— Battery is being charged, charge
level is 67% to 99%
After the beep and vibration signals,
the product switches to empty battery
mode and then switches off.
— Charging the battery outside the
allowable temperature range
— Maintenance required because the
maintenance date has already been
reached or exceeded
— Bluetooth activated
— Battery charger is connected
connecting battery charger)
ment parameters is performed using
the Cockpit app.
If the parameter "Volume of acous­
tic signal" is set to "0" in the Cock­
pit app, only a vibration signal is
emitted.
Required action
Charge battery soon.
Remaining operating time approx. 1 hour.
Charge battery immediately; the product
will be switched off after the next warning
signal.
Charge the battery.
Check whether the specified ambient con­
ditions for charging the battery were met
(see Page 105).
The product must be inspected by an
authorised Ottobock Service Center. For
disassembly of the joint unit, see the sec­
tion "Assembling/disassembling the joint
unit on the orthosis" (see Page 79)
Appendices
109