Otto Bock DynamicArm Plus Instructions For Use Manual page 48

Preparing the product for use
6.6 Plugging in the contact
48
1) After laminating the lamination ring, remove the
grease and any dirt.
2) Lubricate the groove, inner edges and thread of the
lamination ring with 633F30 special grease.
1) Apply a generous amount of 633F11 silicone
grease to the connector contacts of the 13E219
control electronics.
2) Connect the cable.
3) Thoroughly seal the plug and blanking covers from
above with 633F11 silicone grease.
DynamicArm Plus 12K110N=*