Otto Bock DynamicArm Plus Instructions For Use Manual page 45

The lamination ring with quick-disconnect wrist unit has to be glued in after the forearm has been cut to length.
Before starting to glue it in, please read these instructions very carefully and proceed exactly in the order
described.
INFORMATION
Read the relevant material safety data sheets before processing the 636K18 Orthocryl sealing resin compact
adhesive and the 617H14 hardener paste.
DynamicArm Plus 12K110N=*
1) Determine the height of the lamination ring.
2) Mark this measurement on the inside of the fore­
arm.
3) Mix 636K18=1 Orthocryl sealing resin compact
adhesive and 2% 617H14 hardener paste.
4) Cover the outside of the forearm with 627B4 poly­
ethylene adhesive tape to avoid soiling it while glu­
ing.
5) Using a paintbrush, apply the resin in a wedge
shape to the marked area of the inside forearm and
the outside of the lamination ring.
6) Insert the lamination ring and lamination ring cover.
The lamination ring must be flush with the socket!
Let the adhesive joint harden.
INFORMATION: Measure the forearm length.
Preparing the product for use
45