Configuring Smart Ports For Desktops - Cisco ESW 500 Administration Manual

Managing Smart Ports

Configuring Smart Ports for Desktops

NOTE
Configuring Smart Ports for Desktops
ESW 500 Series Switches Administration Guide
By default, the user ports are configured as IP Phone + Desktop for PoE switches
and Desktop for non-PoE switches. For devices other than IP Phone and Desktop,
users need to configure the smartport role per device (e.g., switch, access point
etc.). A port will be deactivated or has degraded service by connecting a switch or
an access point to IP phone + desktop smartport respectively because of
mismatched port role.
For example, if the network administrator knows that ports 1-10 are access points
for a WLAN network, the Smart Ports Wizard is applied to the ports, and the ports
are configured with the most common settings for WLAN networks.
Note the following when using the Smart Ports wizard:
•
During the Boot Process the Smart Port wizard commands are saved in the
Running Configuration file. This ensures that if the device is reset, the Smart
Port wizard settings are applied to the ports when the device restarts
•
Ports are enabled for the Smart Port wizards by default. However, the initial
configuration of the Smart Ports wizards can only occur if the Startup
Configuration file is empty.
•
If the network administrator modifies the port configuration manually, the Smart
ports Wizard may not operate correctly.
Smart Ports for Desktops Page
The
settings for personal desktop users.To configure ports for desktop users using the
Smart Ports Wizard:
allows network administrators to define port
3
62