Cisco ESW 500 Administration Manual page 21

Getting Started
Connecting to the Switch
STEP 10
STEP 11
STEP 12
ESW 500 Series Switches Administration Guide
IPv4 Interface Page
It is expected that the IP address to be assigned to the switch is known prior
NOTE
to installation, based on the network topology.
Select the Static IP address radio button and enter the IP Address, Network Mask
and User Defined Default Gateway. These must match the IP addressing subnet in
the network in which the ESW 500 switch will be deployed. Click Apply.
The PC loses the connection to the switch at this point.
NOTE
Now that you have finished using the PC to connect to the switch and made the
switch part of your network, you can reconfigure the PC to its original IP address
configuration and physical configuration as part of your network.
You are now ready to proceed with additional switch configuration.
1
10