Managing Arp - Cisco ESW 500 Administration Manual

Configuring IP Information

Managing ARP

STEP 3
STEP 4
ARP
Managing
ESW 500 Series Switches Administration Guide
Add DHCP Interface Page
Add DHCP Interface Page
The
•
Interface — Selects the interface to define DHCP Relay. The possible field
value is:
-
VLAN
— Defines the DHCP Relay on the selected VLAN.
Select the Interface on which to define a DHCP Relay.
Click Apply. A DHCP Relay Interface is defined, and the device is updated.
Address Resolution Protocol
The
addresses into physical addresses. The ARP table is used to maintain a correlation
between each MAC address and its corresponding IP address. The ARP table can
be filled in statically by the user. When a static ARP entry is defined, a permanent
entry is put in the table, which the system uses to translate IP addresses to MAC
addresses.
To define ARP:
contains the following field:
(ARP) is a TCP/IP protocol that converts IP
8
236