Configuring Station Management - Cisco ESW 500 Administration Manual

Configuring SNMP
Defining Trap Management
STEP 1
ESW 500 Series Switches Administration Guide

Configuring Station Management

Station Management Page
The
determine whether traps are sent to specific users, and the trap type sent. SNMP
notification filters provide the following services:
•
Identifying Management Trap Targets
•
Trap Filtering
•
Selecting Trap Generation Parameters
•
Providing Access Control Checks
Traps indicating status changes are issued by the switch to specified trap
managers. Specify the trap managers so that key events are reported by this
switch to the management station. Specify up to eight management stations that
receive authentication failure messages and other trap messages from the switch.
Click Monitor & Device Properties > SNMP > Trap Management > Station
Station Management Page
Management. The
Station Management Page
The Station Management Page
Recipient SNMPv3 Notification Recipient
and the
contains information for defining filters that
opens:
contains two areas, the
table.
13
SNMPv1,2 Notification
350