Setting the Hardware Options
This section shows you how:
•
To select the emulator clock source
•
To enable or disable the target BR and BGACK signals
•
To enable or disable the target BERR signal
•
To enable or disable target DTACK for emulation memory accesses
•
To enable or disable target system interrupts
•
To enable or disable break on writes to ROM
•
To specify the TRAP instruction for breakpoints
•
To select the data bus width
•
To specify the target memory access size
•
To select internal or external cycle termination for CS0-3
•
To select /IACK7 pin operation
•
To specify tracing of DMA cycles
•
To select the normal or dedicated interrupt mode
•
To select level or edge sensitivity for /IRQ7
Chapter 3: Configuring the Emulator
Setting the Hardware Options
69