Table of Contents
Advertisement
Chapter 8: Menu Bar Commands
Execution→Step... (ALT, E, S)
Execution→Step... (ALT, E, S)
Single-steps the specified number of instructions or source lines, starting
from the specified address.
Single source lines are executed when in the source only display mode,
unless no source is available or an assembly language program is loaded; in
these cases, single assembly language instructions are executed.
When in the mnemonic mixed display mode, single assembly language
instructions are executed.
Note
If you try to step from an address whose symbol is START or STA (or any
upper- or lower-case variation), the debugger instead steps from the start
address because these are the keywords used with the STEP and OVER
commands. To fix this problem, use START+0 or STA+0 to force the symbol
to be evaluated as an address.
242
Advertisement
Chapters
Table of Contents
