HP 68302 User Manual page 302

Chapter 8: Menu Bar Commands
Settings→Emulator Config→Hardware... (ALT, S, E, H)
CON(FIG) ACC(ESS) WOR(DS)
Specifies that target memory is accessed in 16-bit word sized locations.
CON(FIG) ARB(ITRATION) ENA(BLE)
Enables tracing of the DMA cycles.
CON(FIG) ARB(ITRATION) DIS(ABLE)
Disables tracing of the DMA cycles.
CON(FIG) ARB(ITRATION) TAG
Enables a single state in the trace each time an external bus arbitration
sequence occurs.
CON(FIG) INTMODE NOR(MAL)
Selectes the normal interrupt mode for the emulation microprocessor.
CON(FIG) INTMODE DED(ICATED)
Selectes the dedicated interrupt mode for the emulation microprocessor.
CON(FIG) IAC(K7) PB0
Selects the PB0 pin.
CON(FIG) IAC(K7) IAC(K7)
Selects the IACK7 pin.
CON(FIG) CS0/CS1/CS2/CS3 EXT(ERNAL)
Specifies that the /DTACK cycle termination signal is generated externally.
CON(FIG) CS0/CS1/CS2/CS3 INT(ERNAL)
Specifies that the /DTACK cycle termination signal is generated internally.
Any of the above command file commands must be preceded and followed by
the respective start and end commands:
CON(FIG) STA(RT)
Starts the configuration option command section.
CON(FIG) END
Ends the configuration option command section.
See Also
"Setting the Hardware Options" in the "Configuring the Emulator" chapter.
303