HP 68302 User Manual page 465

Chapter 14: Installing the Debugger
Step 1. Connect the HP 64700 to the PC
Connect an RS-232C modem cable from the PC to the HP 64700 (for
2
example, an HP 24542M 9-pin to 25-pin cable or an HP 13242N 25-pin
to 25-pin cable).
If you want to build your own RS-232 cable, follow one of the pin-outs for HP
cables shown in the following figure.
You can also use an RS-232C printer cable, but you must set HP 64700
configuration switch 4 to 1.
Turn ON power to the HP 64700.
3
The power switch is located on the lower left-hand corner of the front panel.
The power lamp at the lower right-hand corner of the front panel will light.
466