Table of Contents
Advertisement
Chapter 15: Installing/Updating HP 64700 Firmware
Step 2. Install the firmware update utility
Wait until the Setup Exit Message dialog box appears. This indicates
installation of the firmware update utility is complete.
After completing the installation, use the editor of your choice and
4
edit the C:\CONFIG.SYS file to include these lines:
BREAK=ON
FILES=20
BREAK=ON allows the system to check for two break conditions:
CTRL+Break, and CTRL+c.
FILES=20 allows 20 files to be accessed concurrently. This number must be
at LEAST 20 to allow the firmware update utility to operate properly.
If you installed the files in a path other than the default (C:\HP64700),
5
edit the C:\AUTOEXEC.BAT and C:\HP64700\BIN\FLASH.BAT files as
follows:
•
Edit AUTOEXEC.BAT to set the HP64700 and HPTABLES
environment variables. For example:
SET HP64700=C:\<installation_path>
SET HPTABLES=C:\<installation_path>\TABLES
•
Edit FLASH.BAT to identify the location of PROGFLAS.EXE. For
example:
C:\<installation_path>\PROGFLAS.EXE
Edit the <installation_path>\TABLES\64700TAB file to indicate the
6
communications connection you will use, as follows:
The default <installation_path>\TABLES\64700TAB file contains entries to
establish the communications connection for COM1 and COM2. The content
of this file is:
EMUL_COM1 unknown COM1 OFF 9600 NONE ON 1 8
EMUL_COM2 unknown COM2 OFF 9600 NONE ON 1 8
492
Advertisement
Chapters
Table of Contents
