HP 68302 User Manual page 442

•
Any on-screen information that would be periodically updated by
temporarily interrupting user program execution (target system memory
or register contents, for example) is disabled.
WAITING FOR TARGET RESET
The emulation processor is waiting for a RESET signal from the target
system. User program execution starts on reception of the RESET signal.
SLOW CLOCK
No proper clock pulse is supplied from the external clock.
EMULATION RESET BY TARGET
The emulation processor is being held in a reset state by a RESET signal from
the target system.
BUS GRANT TO TARGET SYSTEM DEVICE
The bus is granted to some device in the target system.
NO BUS CYCLE
The bus cycle is too slow or no bus cycle is provided.
HALTED
The emulation processor has halted.
UNKNOWN STATE
The emulation processor is in an unknown state.
Other Emulator Status Messages
The Status window may also contain status messages other than the
emulation processor status messages described above:
BREAK POINT HIT AT module_name#line_number
The breakpoint specified in the source code line was hit and program
execution stopped at "line_number" in "module".
BREAKPOINT HIT AT address
The breakpoint specified in the assembled line was hit and program
execution stopped at "address".
UNDEFINED BREAKPOINT at address
The breakpoint instruction occurred at "address", but it was not inserted by a
breakpoint set command.
Chapter 13: Concepts
Debugger Windows
443