Removing The Cylinder Head; Removing The Piston - Husqvarna FC 250 2015 Repair Manual

17 ENGINE
17 .3.12

Removing the cylinder head

17 .3.13

Removing the piston

Take the timing chain off the camshaft gear.
Remove the camshafts.
O
Remove nut with the washer.
8
Loosen nuts in a crisscross pattern and remove them with the washers.
Remove the cylinder head.
Remove cylinder head gasket (D.
Push the cylinder upward.
• Info
I
Only push the cylinder as far up as necessary to take the piston pin out.
Remove the piston pin retainer
Remove the piston pin.
Take off the cylinder and piston.
Push the piston upward out of the cylinder.
• Info
I
If no further work is to be performed on the cylinder and piston, the piston
can remain in the cylinder.
O.
131