Removing The Stator And Ignition Pulse Generator; Installing The Stator And Ignition Pulse Generator - Husqvarna FC 250 2015 Repair Manual

21 IGNITION SYSTEM
21.4 Removin
21.5
ulse generator
Condition
The alternator cover has been removed.
O.
-
Remove screw
-
Remove retaining bracket.
8.
-
Remove screw
-
Remove cable support sleeve
-
Remove the stator and ignition pulse generator from the alternator cover.
O
-
Blow out oil nozzle with compressed air and check that it is clear.
Guideline
Oil nozzle for alternator
cooling
-
Position the stator and ignition pulse generator in the alternator cover.
-
Mount and tighten screws
I Guideline
Screw, stator
-
Position retaining bracket.
-
Mount and tighten screws
Guideline
Screw, crankshaft posi­
tion sensor
-
Position cable support sleeve
8
from the alternator cover.
M4 2Nm
(1 .5 lbf ft)
8.
I
4 Nm (3 lbf ft)
C,.
M5 6Nm
(4.4 lbf ft)
C,
in the alternator cover.
194
Loctite ® 243 ™
I
®
Loctite 2701
TM
®
Loctite 243 ™