Table of Contents
Advertisement
SHOCK ABSORBER, SWINGARM
9
9.22
Assembling the iston rod
0-
e
/
Preparatory work
-
Assemble the seal ring retainer.
Main work
-
Clamp the piston rod with the fork in a vise.
I
Guideline
Use soft jaws.
-
Mount rubber buffer
-
Position special tool on the piston rod.
I
Mounting sleeve (T1215)
-
Grease the dust boot and push seal ring retainer
I
Lubricant (T625)
-
Remove the special tool.
-
Mount rebound washer
-
Mount the compression shim stack
201418-10
-
Sand both sides of piston
-
Clean the piston.
-
Assemble the piston.
Guideline
ViewO
ViewC,
-
Mount the rebound shim stack @ with the smaller shims facing upward.
201420-10
(ll!;!l
p. 54)
O
8.
and locking cap
(a
p. 232)
(a
p. 221)
8
with the cut-out facing downward.
0
with the smaller shims facing downward.
(D
on a surface plate using 1200-grit sandpaper.
Piston from above
Piston from below
@)
onto the piston rod.
55
Advertisement
Table of Contents
