Assembling The Hydrostop Unit - Husqvarna FC 250 2015 Repair Manual

6
FORK, TRIPLE CLAMP
Assembling the h¥drosto� unit
Info
The steps are identical for both fork legs.
------0------
-
Mount and grease seal ring
I
Lubricant (T158)
-
Mount and grease O-ring
1
Lubricant (T158)
Position pilot bushing support (s).
-
Mount and grease O-ring
I
Lubricant (T158)
-
Mount washer
-
Mount shim stack (s) with the smaller washers facing downward.
-
Mount the new O-ring on hub
-
Mount the hub with washers@).
• Info
I
It is possible that only one or no washer is present.
-
Mount and tighten adapter
Guideline
I
Hydrostop unit adapter
-
Mount shim stack @ with the smaller washers facing downward.
-
Mount and tighten sleeve Q).
Guideline
I
Hydrostop unit sleeve
-
Check distance
Guideline
Hydrostop distance
Hydrostop length
»
If the dimensions are out of tolerance:
-
Add or remove washers
201975-10
O.
(l!J:!1 p. 221)
8-
(l!J:!1 p. 221)
O.
(l!J:!1 p. 221)
8.
C,.
(D.
I
M6x0.5
I
M6x0.5
8
@)
and total length of the hydrostop.
� 1.5 mm (� 0.059 in)
108.5 ... 109.5 mm (4.272 ... 4.311 in)
0.
24
I 7 Nm (5.2 lbf ft)
I 7 Nm (5.2 lbf ft)